Experienced and well skilled Lead Maintenance Technician with more than 15 years in building maintenance. Possesses in-depth knowledge of maintenance, troubleshooting and repair procedures in all areas of facility and mechanical systems for both commercial and residential buildings. Looking to secure a full time position, where I can utilize my hands on mechanical, electrical and leadership experience with a stable and highly reputable company
|
|
Troubleshoot, diagnose and repair facility HVAC and Chiller Units. Responsible for all pipe fitting on production line tooling, for black iron pipe air lines from 1/2" to 4-1/2" in diameter, including the creation of all compression hydraulic hoses and fittings. Troubleshoot and repair Ingersol-Rand Industrial Air Compressor System, as well as 2 Gardner-Denver Compressors. Maintain Facility Generator, Perform Preventative Maintenance on production floor machinery which includes, but is not limited to the following; Miller Mig and Tig Welders, Empire Shot Peens and Roto Peens, Rockford Lathes, Delta Band Saws and Drill Presses, Belt Sanders, Table Saws, Circular Saws, Paint Mixers, C-Squeezers, Manual & Hydraulic Stencils etc. Perform electrical work from 110V - 480V such as hang fixtures, replace ballasts, add circuits and troubleshoot relays. Hang and repair drywall, drop ceilings, concrete work, as well as full plumbing expertise.
.
Responsible for maintenance of entire Palm City, Fl Terminal. Ensured operation of machinery and mechanical equipment by completing preventive maintenance requirements on generators, motors, conveyor belt units, pneumatic tools and hand tools. Repaired and replaced HVAC systems, including air handlers, humidity control systems and all duct work. Maintained facilities irrigation system. Completed all facility electrical repairs such as, replacing ballasts, adding circuit breakers and electrical outlets as well as adding and relocating internet and telephone lines to the existing network. Completed all plumbing repairs such as, water heater, toilet, urinal and sink replacement. Completed all interior repairs such as installation and replacement of drywall, drop ceilings, moldings. Maintained a fleet of 12 EZGO, ClubCar and Yamaha golf carts. Currently hold State of Florida Forklift Certification.
Provided preventative maintenance on four Bascule Bridges located in South Florida.Two of which were hydraulic bridges, while the remaining two were tooth, gear driven bridges. My responsibilities included lubricating all gears, bearings, couplings, motors, brakes, span locks, traffic gates and barrier gates. troubleshoot electric limit switches and GO switches. Test, troubleshoot and install relays and capacitors. Program PLC units to their set parameters based on engineer specifications, as well as troubleshoot, eliminate and clear all PLC faults as they arise. Document all maintenance and repair work in PM Log Book. Provide full compliance with all FDOT, as well as OSHA guidelines, rules and regulations.
Resumes, and other information uploaded or provided by the user, are considered User Content governed by our Terms & Conditions. As such, it is not owned by us, and it is the user who retains ownership over such content.
Companies Worked For:
School Attended
Job Titles Held:
Degrees
© 2021, Bold Limited. All rights reserved.