Knowledgeable Electrical installation technician High Voltage lead who understands installation and repair processes, how
they are carried out and methods to increase efficiency. Professional Equipment operator who has over 15 year experience Bobcats , backhoes , loaders , forklifts , pile drivers / post pounders. Hungry to learn and receive/give knowledge. Focused and takes pride in doing a quality job.
Assembly line production
Blueprint interpretation expertise
Installation and repair specialist
Skilled with ladders and scaffolds
Material handling expert
Extremely quick learner
Hand and power tools
High Voltage Electrical LeadBYD Coach And Buses – 46147 BYD Blvd, Lancaster, CA 93534
High voltage wiring on buses and HV Harness Installation.
Low voltage harnesses and LV wiring installation in buses.
Installation of VTOG's left and right, DC/DC converter.
After sales buses whole bus debugging.
Install AC units on roof of buses.
Operate air, power and hand tools to assemble buses.
Connected and disconnected wiring, piping and tubing.
Installed Amerex fire suppression systems in buses.
Assembled compressors using Work Center Instructions (WCI), Piping and Instrumentation instructions (P and I), Wiring Diagram (WD), Bill of Material (BOM) and assembly drawings.
Planned and paced work efficiently in order to meet daily, weekly, project or production goals.
Closely inspected parts to ensure they were clean and free of contaminants.
Interpreted schematic blueprints, wiring diagrams, performance specifications and service manuals.
Installed electrical and mechanical equipment in accordance with the National Electric Code.
Installed, repaired and tested electrical and electronic systems.
Pile Driver / Fork lift / OperatorEastridge / Swinerton Renewable Energy – Backus rd. Rosamond, CA
Operated Vermeer P10 pile driver and an Orteco pile driver.
Ran P10 with Remote controller without post setter, hooked rigging system and plumed piles by myself.
Set Grade with Laser.
Pounded 13.6" and 13 foot piles in to the ground between 9ft.
to 4.5 depending on the grade.
For the panels to set on.
Pounded over 20 megawatts.
01/2015 to 01/2015
O&M Solar techNext phase solar – Rosamond, CA
Turned off inverters and combiners boxes so my crew could change the 10 amp. fuses and replaced with 12 amp. fuses.
Torqued and ground marked bolts @ 15 ft. lbs and leads @ 45 ft. lbs.
Used power tools , hand tools , torque wrench and impact gun.
11/2014 to 12/2014
Solar Installer/Electrician HelperChampion Electric/Aerotek – Lancaster, CA
Pulled AC/DC home runs
Used fish tape to pull wires through conduit to connect to invertors.
High School Diploma: Quartz Hill High School - Quartz Hill, Ca