Company Owner Resume Example

• Earned good attendance record and built reputation for being on time and ready to work.
• Worked closely with team members to deliver project requirements, develop solutions and meet deadlines.
• Read drawings mechanical, architectural, structural and plumbing.
• Set/install different types of air handling equipment, condensers, air handlers, furnaces, evaporator coils, heat pumps, down shot units, side shot units etc.
• Install many different types of duct systems and sizes, including hanging duct, installed duct on angle legs on equipment decks, round and rectangular ducts on roofs, "s" and drive ducting, TDC ducting and all round sizes from 3 inch round to 32 inch round.
• Install flex ducting and alumaflex ducting.
• Install ceiling registers and attach flex ducting.
• Work with and give signals to cranes that range from 40 ton to 300 ton hydros.
• Set and install exhaust fans and exhaust duct of all different sizes.
• Spot, lay out roof penetrations and build simple lumber curbs on roof for ducts and flashings.
• Run thermostat wire and hook up basic AC units and heat pumps.
• Run copper line sets for split AC systems and braze copper fittings with oxy acetylene torch set.
• Use mechanical and digital gauges on refrigerant systems, read pressure temperature charts for sub cooling and super heat.
• Use vacuum pumps to evacuate line sets to 500 microns or evacuate recovery tanks.
• Pressurize line set systems with nitrogen to check for leaks with gauge sets.
• Install zone systems, install 120v 24v transformers, zone boards and all control wire required to operate the system.
• Basic troubleshooting and repair of rooftop package units, residential condensers and furnaces.
• Charge or weigh in refrigerant to AC or heat pump systems usually R22 or R410A.
• Design basic duct systems, AC tonnage and duct sizes with ductulator or duct size calculator
• Pump down AC systems or recover refrigerant with a recovery unit.
• Pulled mechanical permits at city buildings and worked with inspectors for work sign off.
• Worked with HERS raters as they check duct leakage refrigerant pressures etc.
• Field fabricate sheet metal fittings or pieces.
• Draw detail duct and perform duct "takeoffs" from drawings and have duct or sheetmetal fabricated.
• Knowledge of how to operate scissor lifts, platform lifts, fork lifts and rough terrain fork lifts.
• Travel for work from the west coast to the east coast, Mexico and Costa Rica in charge of a 4 man HVAC crew and get the job done.
• Worked with many different crews and mentored new come

HVAC Installer and Supervisor

• Install commercial exhaust systems in parking garages for apartments, condo towers and business buildings.
• Install AC and heat units and traveling hundreds of miles to different jobs in the country.

HVAC installer and Supervisor

• Set and install commercial AC units and ducting.