Bachelor's Degree: Electrical Technology Management,
2015
United States Navy -
Circuit Analysis, and Ultra sonic emissions. RCM blitz training was also conducted to be able to implement RCFA meetings and to track and resolve bad actors issues. Field Service Engineer Las Vegas, Nv Performed acceptance testing and commissioning, start-up, maintained and installation on all Square D Equipment. Responsible for all of Las Vegas and all surrounding areas i.e. Reno, Laughlin. Supported Arizona and California. Test equipment used on a daily basis include but not limited to Hi-pot, (Ac and Dc) Megger, Ducter, MS2 test set, Multi-function test set, Full function test set. Equipment maintained: Med-Voltage Circuit breakers, Med-Voltage switchgear, Bussing, TVSS, Trip Units, Ground fault systems, Surge logics. Electrical Test Technician Power Engineers Performed acceptance testing and commissioning of a Data Center electrical distribution system to include 100A ductoring of bus ways, physical and voltage checks of disconnect and receptacle boxes, phasing and meggering of low voltage cables using 1kV and 5kV megger, time-current trip testing of circuit breakers ranging from 15A to 3000A using High-Current Test Set, Hi-Potential testing of 25kVcables, wiring inspections of Power Module Distribution Centers, Generator 8 hour load testing and battery over crank testing using infrared thermography, Generator automatic transfer testing, Generator load acceptance and rejection test using a power quality analyzer and 2000kW load bank, winding resistance and insulation resistance test of 2000kW Generator stator windings, fall of potential ground testing, Current Transformer ratio and polarity testing, Potential Transformer ratio and polarity testing, Uninterruptable Power Supply UPS) testing using power quality analyzer, Differential relay testing using through fault tests, and initial energization and switching of 25kVSite Distribution Centers and transformers. Performed acceptance tests on power transformers to include oil sampling, winding resistance test, power factor test, excitation current test, alarm contact verification, meggering of high and low windings, and turns ratio test. Performed acceptance tests on 25kV vacuum circuit breakers to include ductoring main contacts, Hi-Potential testing of vacuum bottles, and insulation resistance. Gas Turbine Electrical Technician (GSE) Operate and perform advanced organizational and/or intermediate maintenance to the component level of gas turbine main propulsion and electrical power generating plant control systems onboard a Navy Cruiser. Team leader in the planning and fulfillment of numerous special projects in main Engineering Department in preparation for ship's formal decommissioning. Troubleshot and restored ships entire gas turbine engine electronics control system including power supplies, electronic control systems, circuit cards and myriad plant electrical/electronics, restoring ship from near zero to 100% operational status in only three weeks of service. Awarded the prestigious Navy Achievement Medal for efforts in controlling a Major fuel oil leak. Electrical Technology Management
Associate's Degree: Electrical Technology Management Electro Mechanical Studies,
Excelsior College - City,
State
Electrical Technology Management Electro Mechanical Studies
Shipboard Propulsion Fuels & Oils and JP-5 Testing and Treatment General and Advanced Shipboard Damage Control (Emergency Response) and Fire Fighting * Engineering Electrical Core School, 13 Weeks, Class Leader) * Gas Turbine Mechanical / Electrical Primary ("A") School, 8 Weeks, Engineering Mechanical Core, 4 Weeks, Engineering Common Core School, 3 Weeks, Sept 1997 * Naval Recruit Training, 10 Weeks, : Electro Mechanical Studies,
May 1998
Excelsior College - City,
State
Electro Mechanical Studies